RL V6-3474cc 3.5L (1998)
Brake Pad: Service and Repair
Rear
Inspection and Replacement
WARNING
-
Never use an air hose or dry brush to clean brake assemblies.
-
Use an OSHA-approved vacuum cleaner to avoid breathing brake dust.
-
Block the front wheels before jacking up the rear of the vehicle.
NOTE: '96 - 98 models shown.
1. Block the front wheels, loosen the rear wheel nuts slightly, support the rear of the vehicle on safety stands, then remove the rear wheels.
2. Remove the brake hose bracket from the trailing arm.
3. Remove the caliper bolt, and pivot the caliper up out of the way. '99 - 01 models only: Hold the caliper pin with a wrench, being careful not to
damage the pin boot. Remove the caliper bolt with another wrench, and pivot the caliper up out of the way.
CAUTION:
-
Thoroughly clean the outside of the caliper to prevent dust and dirt from entering inside.
-
Support the caliper with a piece of wire so it does not hang from the brake hose.
NOTE: Check the hoses and pin boots for damage and deterioration.
4. Remove the pad shims, pad retainers, and pads.
