RL V6-3474cc 3.5L (1998)
NOTE: Do not disconnect the wheel sensor connector.
7. Remove the caliper bracket mounting bolts, and hang the caliper assembly to one side.
CAUTION: To prevent accidental damage to the caliper or brake hose, use a short piece of wire to hang the caliper from the undercarriage.
8. Remove the 6 mm brake disc retaining screws.
CAUTION: Be careful not to damage the ball joint boot.
9. Screw two 8 x 12 mm bolts into the disc to push it away from the hub.
NOTE: Turn each bolt two turns at a time to prevent cocking the disc excessively.
10. Clean any dirt or grease off the ball joint.
11. Remove the cotter pin from the ball joint castle nut, and remove the nut.
12. Install a 12 mm hex nut on the ball joint. Make sure the 12 mm hex nut is flush with the ball joint pin end to prevent damage to the threaded end of
the ball joint.
