RL V6-3474cc 3.5L (1998)
Brake Bleeding: Service and Repair
Conventional Brake System
Bleeding
CAUTION:
-
Always use Genuine Honda DOT 3 Brake Fluid. Using a non-Honda brake fluid can cause corrosion and decrease the life of the system.
-
Make sure no dirt or other foreign matter is allowed to contaminate the brake fluid.
-
Do not spill brake fluid on the vehicle, it may damage the paint; if brake fluid does contact the paint, wash it off immediately with water.
NOTE: The reservoir on the master cylinder must be at the MAX (upper) level mark at the start of bleeding procedure and checked after bleeding
each brake caliper. Add fluid as required.
1. Make sure the brake fluid level in the reservoir is at the MAX (upper) level line.
2. Have someone slowly pump the brake pedal several times, then apply steady pressure.
