RL V6-3474cc 3.5L (1998)
Electronic Brake Control Module: Service and Repair
Removal/Installation
1. Remove the glove box.
2. Remove the glove box back cover.
3. Remove the right front door trim.
4. Remove the right kick panel.
5. Turn up the floor mat.
6. Remove the PCM cover.
7. Remove the connectors inside of the right kick panel.
8. Remove the harness clip A form the ABS control unit, then remove the bolt at lower side of the ABS control unit.
9. Remove the multiplex control unit (Passenger's).
10. Remove the harness clip B and C.
11. Remove the bolt at rear of the ABS control unit, then pull out the ABS control unit.
12. Install the ABS control unit in the reverse order of removal.
