RL V6-3474cc 3.5L (1998)
Heater Control Valve Cable: Adjustments
Heater valve side:
1. Open the cable clamp, then disconnect the heater valve cable from the heater valve arm.
2. Set the temperature control dial on MAX COOL with the A/C on
NOTE: Do not start the engine.
3. Turn the heater valve arm to the fully closed position as shown above, then attach the heater valve cable to the heater valve arm. Hold the heater
valve arm in the closed position, and gently pull on the heater valve cable housing to take up any slack, then install the heater valve cable housing
into the cable clamp.
Heater unit side:
1. At the heater unit, disconnect the heater valve cable housing from the cable clamp, then disconnect the heater valve cable from the temperature
control arm.
2. Set the air mix control motor on MAX COOL.
3. Attach the heater valve cable to the temperature control arm as shown above. Hold the end of the heater valve cable housing against the stop, then
snap the heater valve cable housing into the cable clamp.
