RL V6-3474cc 3.5L (1998)
Evaporator Temperature Sensor / Switch: Testing and Inspection
Component Test
Compare the resistance reading between the No.1 and No.2 terminals of the evaporator temperature sensor with the specifications shown in following
graph; resistance should be within specifications.
NOTE: Dip the sensor in ice water, and measure resistance. Then pour hot water on the sensor, and check for change in resistance.
CAUTION: The sensor uses a thermistor which can be damaged if high current is applied during testing. Therefore, use a circuit tester with an output
of 1 mA or less at the 20 k ohms range.
