RL V6-3474cc 3.5L (1998)
REPAIR PROCEDURE
1.
Turn on the headlights (low beam). Turn on the fog light switch. Check for battery voltage across the terminals of the 2P connector of each
affected fog light with a multimeter.
If there is battery voltage across the terminals, turn off the lights, and go to step 2. If there is no battery voltage across the terminals, do not
proceed. Continue with normal troubleshooting procedures.
2.
Unplug the 2P connector from an affected fog light.
3.
Remove the rubber cover. Note the alignment of the cover (the word "TOP" points straight up and the drain tubes point straight down).
4.
Unclip the hold-down wire, and remove the bulb and socket.
5.
Replace the bulb and socket with the parts from the kit.
-
If the existing socket is white, replace the bulb and the socket in both fog lights.
-
If the existing socket is black, replace only the bulb. Replace the bulb in the other fog light only if it is affected.
6.
Clip the hold-down wire into place.
7.
Reinstall the rubber cover.
8.
Plug in the 2P connector.
9.
Make sure the fog lights work properly.
