RL V6-3474cc 3.5L (1998)
Balance Shaft Belt: Service and Repair
Removal and Installation
REMOVAL
NOTE:
-
Replace the timing belt and timing balance belt at 105,000 miles (168,000 km) according to the maintenance schedule (normal conditions, severe
conditions). If the vehicle regularly is driven in one or more of the following conditions, replace the timing belt and timing balancer belt at 60,000
miles (U.S.A.) 100,000 km (Canada).
-
In very high temperatures (over 110°F, 43°C).
-
In very low temperatures (under -20°F, -29°C).
-
Turn the crankshaft pulley so the No. 1 piston is at Top Dead Center (TDC) before removing the belt.
-
Inspect the water pump before installing the timing belt.
1. Remove the engine cover.
2. Remove the intake air duct and air cleaner housing assembly.
3. Loosen the mounting bolt, lock bolt and adjusting rod, then remove the alternator belt.
4. Loosen the idler pulley center nut and adjusting bolt, then remove the Air Conditioning (A/C) compressor belt.
5. Remove the TCS control valve upper and lower brackets.
6. Loosen the adjusting bolt, locknut and mounting bolt, then remove the Power Steering (P/S) pump belt.
