RL V6-3474cc 3.5L (1998)
2.
Remove the PCM cover (four nuts).
3.
Remove the PCM. Disconnect the electrical connectors.
4.
Connect the electrical connectors to the new PCM. Install the PCM.
5.
Reinstall the PCM cover. Torque the mounting nuts to 9.8 Nm (7.2 lb-ft).
6.
Reinstall the carpet and the door sill molding.
7.
Connect the PGM Tester to the Data Link Connector. Make sure the PGM Tester has software version SN 902 or later.
8.
Select # 5 (IMMOBI) from the MAIN menu.
9.
From the IMMOBI menu, select # 1 (REWRITE).
10.
From the REWRITE menu, select # 2 (ECM) and continue to follow the screen prompts.
Disclaimer
