RL V6-3474cc 3.5L (1998)
4. Remove the airbag(s):
-
Remove the two mounting nuts from the bracket.
-
Lift the front passenger's airbag out of the dashboard by covering the lid and dashboard with a cloth, and prying carefully with a flat-tip
screwdriver.
NOTE: The lid of the airbag has pawls on its side which attach it to the dashboard.
CAUTION: Be sure to install the SRS wiring so that it is not pinched or interfering with other parts.
5. Install new airbag(s):
-
Place the front passenger's airbag in the dashboard.
-
Tighten the front passenger's airbag mounting nuts.
6. Reconnect the airbag connector(s)
-
Connect the driver's airbag 2P connector to the cable reel 2P connector, then install the access panel on the steering wheel.
7. Reconnect the battery positive cable, then connect the negative cable.
8. After installing the airbag, confirm proper system operation:
-
Turn the ignition switch ON (II); the SRS indicator light should come on for about six seconds and then go off.
-
Make sure horn button works.
-
Take a test drive, and make sure the cruise control switches work.
9. Enter the anti-theft code for the radio, then enter the customer's radio station presets.
