RL V6-3474cc 3.5L (1998)
Seat Belt: Service and Repair
Front Seat Belt Replacement
SRS components are located in this area. Review the SRS component locations, precautions, and procedures before performing repairs or service.
CAUTION: Check the front seat belts for damage, and replace then if necessary. Be careful not to damage them during removal and installation.
Front seat belt:
1. Make sure you have the anti-theft code for the radio, then write down the frequencies for the preset buttons.
2. Disconnect the negative battery cable, and wait at least 3 minutes before beginning work.
3. Slide the front seat forward fully.
4. Remove:
-
Front and rear side trim.
-
Front and rear door trim.
5. Remove the lower anchor cap, then remove the lower anchor bolt.
6. Remove the center pillar trim.
7. Disconnect the seat belt tension reducer connector and seat belt tensioner connector.
WARNING: To avoid accidental deployment and possible injury, always disconnect the seat belt tensioner connector before removing
the retractor.
8. Remove the upper anchor bolt and retractor bolt, remove the retractor mounting bolt, then remove the front seat belt and retractor.
