RL V6-3474cc 3.5L (1998)
Seat Belt Tensioner Reduction Solenoid: Service and Repair
Disconnecting Seat Belt Tensioner Connectors
Before removing an airbag or other SRS related devices (the SRS unit and the cable reel), disconnecting connectors from SRS related devices, or
removing the dashboard or the steering column, disconnect the airbag connectors to prevent accidental deployment.
Turn the ignition switch OFF and disconnect the negative cable from the battery, and wait at least three minutes before beginning the following
procedures.
Before disconnecting the SRS main harness 18P connector (A) from the SRS unit, disconnect both airbag 2P connectors (C, D) and both seat belt
tensioner 2P connectors (F, H).
Before disconnecting the cable reel 2P connector (B), disconnect the driver's airbag 2P connector (C).
Before disconnecting the left side wire harness 2P connector (E), disconnect the driver's seat belt tensioner 2P connector (F).
Before disconnecting the right side wire harness 2P connector (G), disconnect the front passenger seat belt tensioner 2P connector (H).
1. Disconnect the battery negative cable, then disconnect the positive cable from the battery, and wait at least three minutes.
2. Disconnect the driver's and front passenger's airbag connectors. Disconnect the driver's and front passenger's seat belt tensioner connectors, then
disconnect the driver's and front passenger's side airbag connectors.
NOTE: For disconnecting the spring-loaded lock type connector, see Spring-Loaded Lock connector.
Driver's 2p Connector
