RL V6-3474cc 3.5L (1998)
Seat Belt Tensioner Reduction Solenoid: Service Precautions
Disconnecting the Seat Belt Tensioner Connectors
Before removing a frontal airbag, side airbag or other SRS related devices (the SRS unit, the cable reel, the side impact sensor and the seat belt tensioner
connector), disconnecting connectors from related devices, or removing the dashboard or the steering column, disconnect the airbag connectors or the
side airbag connectors to prevent accidental deployment. Turn the ignition switch OFF and disconnect the negative cable from the battery, and wait at
least three minutes before beginning the following procedures.
- Before disconnecting the SRS main harness 18P connector (A) from the SRS unit, disconnect driver's airbag 2P connector (C) and front passenger's
airbag 4P connector (D).
- Before disconnecting the SRS floor harness 18P connector (E) from the SRS unit, disconnect both seat belt tensioner 2P connectors (G, I), both side
airbag 2P connectors (J, K).
- Before disconnecting the cable reel 2P connector (B), disconnect the driver's airbag 2P connector (C).
- Before disconnecting the left side wire harness 2P connector (F), disconnect the driver's seat belt tensioner 2P connector (G).
- Before disconnecting the right side wire harness 2P connector (H), disconnect the front passenger's seat belt tensioner 2P connector (I).
1. Disconnect the battery negative cable, then disconnect the positive cable from the battery, and wait at least three minutes.
2. Disconnect the driver's and front passenger's airbag connectors, disconnect the driver's and front passenger's seat belt tensioner connectors then
driver's and front passenger's side airbag connectors.
Seat Belt Tensioner:
1. Remove the left and right "B" pillar trim panel.
2. Disconnect both seat belt tensioner 2P connectors from the left (driver's side) or right (front passenger's side) side wire harness.
NOTE: When disconnected, the seat belt tensioner connector is automatically shorted.
