RL V6-3474cc 3.5L (1998)
2. Insert the brush into the brush holder, and bring the brush into contact with the commutator, then attach a spring scale to the spring. Measure the
spring tension at the moment the spring lifts off the brush.
Starter Brush Inspection
Brush Length
Measure the brush length. If the length not within the service limit, replace the brush holder assembly.
NOTE: To seat new brushes after installing them in their holders, slip a strip of #500 or #600 sandpaper, with the grit side up, over the commutator, and
smoothly rotate the armature. The contact surface of the brushes will be sanded to the same contour as the commutator.
Planetary Gear Inspection
