RL V6-3474cc 3.5L (1998)
Air Bag(s) Arming and Disarming: Service and Repair
Air Bag Disarming and Arming
Before removing a front airbag, side airbag or other SRS related devices (the SRS unit, the cable reel, the side impact sensors and the seat belt tensioner
connector), disconnecting connectors from related devices, or removing the dashboard or the steering column, disconnect the airbag connectors or the
side airbag connectors to prevent accidental deployment. Turn the ignition switch OFF and disconnect the negative cable from the battery, and wait at
least 3 minutes before beginning the following procedures.
-
Before disconnecting the SRS main harness 18P connector (A) from the SRS unit, disconnect driver's airbag 2P connector (C) and front
passenger's airbag 4P connector (D).
-
Before disconnecting the SRS floor harness 18P connector (F) from the SRS unit, disconnect both seat belt tensioner 2P connectors (G, I), both
side airbag 2P connectors (J, K).
-
Before disconnecting the cable reel 2P connector (B), disconnect the driver's airbag 2P connector (C).
-
Before disconnecting the left side wire harness 2P connector (F), disconnect the driver's seat belt tensioner 2P connector (G).
-
Before disconnecting the right side wire harness 2P connector (H), disconnect the front passenger's seat belt tensioner 2P connector (I).
1. Disconnect the battery negative cable, then disconnect the positive cable from the battery, and wait at least 3 minutes.
2. Disconnect the driver's and front passenger's airbag connectors. Disconnect the driver's and front passenger's seat belt tensioner connectors, then
disconnect the driver's and front passenger's side airbag connectors.
NOTE: For more information refer to Spring-Loaded Lock Connector. See: Restraint Systems/Air Bag Systems/Testing and Inspection/Initial
Inspection and Diagnostic Overview/Backprobing Spring-Loaded Lock Connectors
Driver's Airbag:
