RL V6-3474cc 3.5L (1998)
-
There may be the sliding marks from the seal ring on the wall of the valve housing. Replace the valve housing only if the wall is stepped.
-
'96 - 98 model only; when the valve housing is replaced, install new 44 mm shim(s) on the bearing surface of the housing to adjust the
thickness.
28. Check for wear, burrs and other damage to the edges of the grooves in the sleeve.
NOTE: The pinion shaft and sleeve are a precision matched set. If either the pinion shaft or sleeve must be replaced, replace both parts as a
set.
29. Remove the snap ring and pinion shaft sleeve from the pinion shaft.
