RL V6-3474cc 3.5L (1998)
29. Press the pinion shaft/sleeve into the valve housing using a hydraulic press.
30. Apply steering grease on the valve oil seal, and install the pinion dust cover on the valve body unit.
Steering Rack Installation
31. If the rubber stop was removed, position the new rubber stop in the gearbox housing, then press it in using a hydraulic press and the special
tools.
NOTE: Make sure that the special tool presses against the metal portion of the rubber stop.
32. Coat the piston seal ring guide with power steering fluid, and slide it onto the rack, big end first.
33. Position the new O-ring and new piston seal ring on the special tool, then slide them down toward the big end of the tool.
NOTE:
-
Do not over expand the resin seal rings. Install the resin seal rings with care so as not to damage them. After installation, be sure to contract
the seal ring using the special tool (sizing tool).
-
Replace piston's O-ring and seal ring as a set.
