RL V6-3474cc 3.5L (1998)
Shift Cable: Service and Repair
Replacement
WARNING:
-
Make sure lifts, jacks, and safety stands are placed properly.
-
Apply the parking brake, and block the rear wheels so the vehicle will not roll off the stands and fall on you while working under it.
1. Raise the front of the vehicle, and support it with safety stands.
2. Set the parking brake, and block both rear wheels securely.
3. Shift the transmission into the N position.
4. Remove the center console.
5. Shift the transmission into the 1 position.
6. Remove the self-locking nut and shift cable end collar, then remove the shift cable from the shift lever link.
CAUTION: Take care not to bend the shift cable.
7. Pull the carpet back to expose the secondary H02S connector. Disconnect the connector, then push it to outside.
NOTE: The secondary H02S connector is located under the passenger's seat.
8. Remove the exhaust pipe A bracket, then remove exhaust pipe A.
9. Remove the secondary H02S harness cover, then remove the three way catalytic converter.
