RL V6-3474cc 3.5L (1998)
14. Turn the air valve on to dry the system out with air for two full minutes or until no moisture is visible leaving the drain hose.
CAUTION: Residual moisture in the cooler or lines can damage the transmission.
15. Remove the flusher from the cooler line. Attach the drain hose to a container.
16. Install the transmission, and leave the drain hose attached to the cooler line.
17. Make sure the transmission is in the P position. Then fill the transmission with ATF, and run the engine for 30 seconds or until approximately 0.95
l (1.0 US quarts, 0.8 Imp quarts) is discharged.
18. Remove the drain hose, and reconnect the cooler return hose to the transmission (see next column).
19. Refill the transmission with the recommended ATF to the proper level.
TOOL MAINTENANCE
1. Empty and rinse after each use. Fill the can with water and pressurize the can. Flush the discharge line to ensure that the unit is clean.
2. If discharge liquid does not foam, the orifice may be blocked.
3. To clean, disconnect the plumbing from the tank at the large coupling nut.
4. Remove the in-line filter from the discharge side and clean if necessary.
5. The fluid orifice is located behind the filter. Clean it with the pick stored in the bottom of the tank handle, or blow it clean with air. Securely
reassemble all parts.
