RSX L4-2.0L (2005)
Paint: Service and Repair
Intermediate Coating
Intermediate Coating
1. Masking
Mask the area surrounding the damage to protect it from the intermediate coat overspray.
Use masking tape and paper.
2. Spraying top coat enamel
Spray the top coat enamel over the surface until the primer surfacer is fully covered.
-
Use the 2-part polyester urethane top coat enamel and a spray gun.
-
Mix the top coat enamel with the additive and solvent in the correct ratio.
-
Follow the top coat manufacturer's instructions.
3. Drying
After spraying top coat enamel, allow for 5-10 minutes of normal drying time, then force dry it with infrared lamps or other industrial dryer.
NOTE:Follow the top coat manufacturer's instruction for drying time.
4. Polishing
Check that the top coat enamel has dried thoroughly, then sand the top coat enamel.
Use the double action sander and #600-#800 disc papers.
NOTE: Be careful not to polish down to the primer surfacer.
When the painting repair is almost done, polish the area that will be top coated.
Use the #2000 sandpaper and compound.
5. Air blowing/degreasing
Use alcohol, and wax and grease remover.
