RSX L4-2.0L (2005)
1. Any adhesion or roughness on the top coat should be wet sanded and repaired.
Use the #1200-#2000 sandpaper and a flexible block.
2. Polish all roughness caused by sanding.
NOTE: Clear the top coat surface frequently so you don't damage the clear coat with the polishing particles.
Use a buffing towel, buffing wool, and compound.
3. Finishes up with buffing.
NOTE:
-
Do not use a power buffer.
-
Don't polish too much; use light hand pressure.
Use a buffing sponge, fine compound, very fine compound, then ultra fine compound.
4. After buffing, remove the masking paper and tape, and thoroughly wash the entire vehicle.