RSX L4-2.0L (2005)
Paint: Service and Repair
Top Coating
Top Coating
1. Masking
Mask the area surrounding the damage to protect it from the top coat overspray.
Use masking tape and paper.
2. Spraying top coat enamel / clear coat
Spray 2-3 coats until the intermediate coat is fully covered.
NOTE:
-
Do not cover the surface with one heavy coat.
-
Apply several thin coats.
-
Use the 2-part polyester urethane top coat enamel and a spray gun.
-
Mix the top coat enamel with the additive and solvent in the correct ratio.
-
Follow the top coat manufacturer's instructions.
After spraying the top coat enamel, allow for 5-10 minutes drying time before you spray the clear coat.
Drying
NOTE: Take care not to let the heat lamp deform the bumper during the drying process.
After spraying the clear coat, allow for 5-10 minutes drying time before you force dry it with infrared lamps or other industrial dryer.
3. Polishing / buffing
-
Check that the clear coat has dried thoroughly.
-
Wet sand to remove any imperfections.
Use a flexible block, soap, and #2000 sandpaper.
-
Using a buffer and compound, remove any polishing marks made from the sandpaper.
Use a buffing sponge, and buffing wool and compounds.
Finish up with buffing:
1. Wet sand with #2000 sandpaper and soapy water.
2. Remove moisture using compressed air.
