RSX L4-2.0L (2005)
10. Install the cable assembly in the reverse order of removal, and note these items:
-
Worn or damaged parts should be replaced.
-
Apply multipurpose grease to the groove portions of the lifter (A) and slide stop link (B) and to the sliding portions of the guide rail (C)
indicated by the arrows.
-
After reinstalling the cable assembly (D) on the frame (E), fill the groove in both grommets (F) with sealant (G).
-
Check the frame seal.
-
When reinstalling the anchor rod (H), insert it into the guide rail (I) by turning the stop (J) 90 °.
-
Take care not to twist or lift the drain channel seal.
-
Before reinstalling the motor, align the tilt-up position of the lifter (K) on each side. Be sure the bushing (L) on the glass bracket (M) contacts
the top end of the groove (N) in the lifter.
-
Before reinstalling the motor, install the frame and glass, then check the opening drag.