RSX L4-2.0L (2005)
6. To remove the rear drain valve (A) from the cargo area, remove the cargo area side trim panel, left or right. Release the rear drain tube (B) from
the clip (C), and tie a string to the end of the drain tube, then pull the drain tube down out of the C-pillar.
7. Install the frame and drain tube in the reverse order of removal, and note these items:
-
Before installing the frame, clear the drain tubes and drain valves using compressed air.
-
Check the frame seal.
-
Clean the surface of the frame.
-
When installing the frame, first attach the rear hooks into the body holes.
-
Make sure the connector is plugged in properly.
-
When connecting the drain tube, slide it over the frame nozzle at least 10 mm (0.39 in.).
-
Install the tube clip (A) on the drain tube (B) as shown.
8. Check for water leaks. Use free-flowing water from a hose without a nozzle. Do not use high-pressure water.
