RSX L4-2.0L (2005)
Vacuum Brake Booster: Service and Repair
Brake Booster Replacement
1. Remove the master cylinder.
2. Disconnect the vacuum hose (A) from the brake booster.
3. Remove the master cylinder brake lines (B) from the brake line holder.
4. Remove the lock pin (A) and the joint pin (B), then disconnect the yoke from the brake pedal.
5. Remove the brake booster mounting flange nuts (C).
6. Remove the brake booster (A) from the engine compartment.
NOTICE:
^
Be careful not to damage the booster surfaces and threads of the booster stud bolts.
^
Be careful not to bend or damage the brake lines.
7. Install the brake booster in the reverse order of removal, and note these items:
^
Adjust the pushrod clearance before installing the brake booster.
^
Use a new lock pin whenever installing.
^
After installing the brake booster and master cylinder, fill the reservoir with new brake fluid, bleed the brake system, and adjust the brake
pedal height and free play.
