RSX L4-2.0L (2005)
6. Inspect the cover washers (C). Replace any washer that is damaged or deteriorated.
7. Tighten the bolts in two or three steps. In the final step, tighten all bolts, in sequence, to 9.8 Nm (1.0 kgf-cm, 7.2 ft. lbs.).
NOTE:
^
Wait at least 30 minutes before filling the engine with oil.
^
Do not run the engine for at least 3 hours after installing the cylinder head.
8. Install the dipstick (A) and breather hose (B).
9. Tighten the bolt (C) securing the power steering hose bracket.
10. Install the four ignition coils.
11. Check that all tubes, hoses, and connectors are installed correctly.
12. Install the intake manifold cover.
