RSX L4-2.0L (2005)
11. Install the EVAP canister hose (A), brake booster vacuum hose (B), and vacuum hoses (C).
12. Install the intake manifold cover.
13. After installation, check that all tubes, hoses, and connectors are installed correctly.
14. Inspect for fuel leaks. Turn the ignition switch ON (II) (do not operate the starter) so that the fuel pump runs for about 2 seconds and pressurizes
the fuel line. Repeat this operation two or three times, then check for fuel leakage at any point in the fuel line.
15. Refill the radiator with engine coolant, and bleed air from the cooling system with the heater valve open.
16. Clean up any spilled engine coolant.
