RSX L4-2.0L (2005)
Air Door Actuator / Motor: Testing and Inspection
Air Mix Control Motor
Air Mix Control Motor Test
1. Disconnect the 5P connector from the air mix control motor.
NOTE: Incorrectly applying power and ground to the air mix control motor will damage it. Follow the instructions carefully.
2. Connect battery power to the No.1 terminal of the air mix control motor, and ground the No. 2 terminal; the air mix control motor should run, and
stop at Max Cool. If it doesn't, reverse the connections; the air mix control motor should run, and stop at Max Hot.
3. If the air mix control motor did not run in step 2, remove it, then check the air mix control linkage and door for smooth movement.
-
If the linkage and the door move smoothly, replace the air mix control motor.
-
If the linkage or the door sticks or binds, repair them as needed.
-
If the air mix control motor runs smoothly, go to step 4.
4. Measure the resistance between the No. 4 and No. 5 terminals. It should be between 2.1 to 3.9 kOhm.
5. Reconnect the air mix control motor 5P connector, then turn the ignition switch ON (II).
6. Using the backprobe set, measure the voltage between the No. 3 and No. 4 terminals.
Max Cool - about 1 V
Max Hot - about 4 V
7. If either the resistance or voltage readings are not as specified, replace the air mix control motor.