RSX L4-2.0L (2005)
Condenser HVAC: Service and Repair
A/C Condenser Replacement
1. Recover the refrigerant with a recovery/recycling/charging station.
2. Remove the front bumper.
3. Remove the nut and the bolt, then disconnect the discharge line (A) and the A/C condenser line (B) from the A/C condenser. Plug or cap the lines
immediately after disconnecting them to avoid moisture and dust contamination.
4. Remove the mounting bolts, then remove the A/C condenser by lifting it up. Be careful not to damage the radiator or the A/C condenser fins when
removing the A/C condenser.
5. Install the A/C condenser in the reverse order of removal, and note these items:
-
If you're installing a new A/C condenser, add refrigerant oil (KEIHIN SP-10).
-
Replace the O-rings with new ones at each fitting, and apply a thin coat of refrigerant oil before installing them. Be sure to use the correct
O-rings for HFC-134a (R-134a) to avoid leakage.
-
Immediately after using the oil, reinstall the cap on the container, and seal it to avoid moisture absorption.
-
Do not spill the refrigerant oil on the vehicle; it may damage the paint. If the refrigerant oil contacts the paint, wash it off immediately.
-
Be careful not to damage the radiator or the A/C condenser fins when installing the A/C condenser.
-
Charge the system.
