RSX L4-2.0L (2005)
-
ECM/PCM idle learn procedure.
-
Power window control unit reset procedure.
-
Enter the anti-theft codes for the radio, then enter the customer's radio station presets.
-
Reset the clock.
Without the HDS
1. Make sure you have the anti-theft codes for the radio (and navigation system, if equipped), then write down the frequencies for the radio's preset
buttons.
2. Remove the glove box, then remove PGM-FI main relay 2 (FUEL PUMP) (A) from the under-dash fuse/relay box.
3. Start the engine, and let it idle until it stalls.
NOTE: If any DTCs are stored, clear and ignore them.
4. Turn the ignition switch OFF.
5. Remove the fuel fill cap, and relieve the pressure in the fuel tank.
6. Disconnect the negative cable from the battery.
7. Check the fuel quick-connect fitting for dirt, and clean it if needed.
8. Place a rag or shop towel over the quick-connect fitting (A).
