RSX L4-2.0L (2005)
5. If four numbers or marks (1 to 4 or v to vvvv) are printed around the outside of the filter, use the following procedure to tighten the filter.
^
Spin the filter on until its seal lightly seats against the block/oil cooler, and note which number or mark is at the bottom.
^
Tighten the filter by turning it clockwise three numbers or marks from the one you noted. For example, if number 2 is at the bottom when the
seal is seated, tighten the filter until the number 1 comes around the bottom.
6. After installation, fill the engine with oil up to the specified level, run the engine for more than 3 minutes, then check for oil leakage.
