RSX L4-2.0L (2005)
13. Check for continuity between ECM/PCM connector terminal E29 and body ground.
Is there continuity?
YES - Repair short in the wire between the ECM/PCM (E29) and DLC.
NO - Go to step 14.
14. Disconnect the gauge assembly B (20P) connector.
15. Check for continuity between ECM/PCM connector terminal E31 and body ground.
Is there continuity?
YES - Repair short in the wire between the ECM/PCM (E31) and the gauge assembly.
NO - Update the ECM/PCM if it does not have the latest software, or substitute a known-good ECM/PCM, then recheck. If the
symptom/indication goes away with a known good ECM/PCM, replace the original ECM/PCM.
16. Try to start the engine.
Does the engine start?
YES - Go to step 25.
NO - Go to step 17.
17. Turn the ignition switch OFF.
18. Connect ECM/PCM connector terminal E31 to body ground with a jumper wire.
19. Turn the ignition switch ON (II).