RSX L4-2.0L (2005)
Information Bus: Diagnostic Trouble Code Tests and Associated Procedures
Mode 1 Test
Special Tools Required
MFCS service connector 07WAZ-001010A
Mode 1 Test
NOTE: Check for ECM/PCM DTC(s). Troubleshoot and repair the cause for the DTC(s) first.
1. Remove the driver's dashboard lower cover.
2. Check the No. 9 (10 A) fuse in the under-hood fuse/relay box and the No. 10 (7.5 A) fuse in the under-dash fuse/relay box.
Are the fuses OK?
YES - Go to step 3.
NO - Find and repair the cause of the blown fuse.
3. Turn the ignition switch ON (II).
If the driver's seat belt is unbuckled, the seat belt reminder will beep 6 times.
4. Set the ceiling light to the middle position and close all the doors.
5. Connect the special tool (A) to the multiplex inspection connector (B).
6. After about 5 seconds, the ignition key light and ceiling light should come on for 2 seconds, go out, then blink on for 0.2 second to show the
system is now in Mode 1.
Did the ignition key light and ceiling light indicate mode 1?
YES - Go to step 8.
NO - Go to step 7.
7. Check for continuity between the No. 4 terminal of the under-dash fuse/relay box connector J and body ground.
Is there continuity?
YES - Replace the under-dash fuse/relay box.
NO - Repair the open in the wire. If the wire is OK, repair G301.
8. If there are any DTCs present, the ignition key light and ceiling light will blink to indicate the DTC(s). If more than one DTC is present, the DTCs
