RSX L4-2.0L (2005)
8. Coat the new O-rings (A) with clean engine oil, and insert the injectors (B) into the fuel rail (C).
9. Install the injector clip (D).
10. Coat the injector O-ring (E) with clean engine oil.
11. To prevent damage to the O-ring, install the injectors in the fuel rail first, then install them in the injector base (F).
12. Install the fuel rail mounting nuts.
13. Connect the connectors on the injectors, and install the harness holder.
14. Connect the quick-connect fittings.
15. Turn the ignition switch ON (II), but do not operate the starter. After the fuel pump runs for approximately 2 seconds, the fuel pressure in the fuel
line rises. Repeat this two or three times, then check for fuel leakage.
16. Install the engine cover.
