acura Workshop Repair Guides

Acura (Honda) Workshop Service and Repair Manuals

Computers/Controls - Updating Control Units And Modules|Page 3992 > < Computers/Controls - Updating Control Units And Modules|Page 3990
Page 1
background image

PROM - Programmable Read Only Memory: All Technical Service Bulletins
Engine Controls - MIL ON/DTC's P1172 or P2A00

07-019

April 12, 2007

Applies To: 
2005-06 RSX - ALL

MIL Is On With DTC P1172 or P2A00

SYMPTOM

The MIL is on with PGM-FI DTC P1172 (air fuel sensor [sensor 1] circuit out of range, high) and/or P2A00 (air fuel sensor [sensor 1] circuit
range/performance problem) stored.

PROBABLE CAUSE

The air/fuel sensor is damaged by moisture in the exhaust system during engine warm up.

CORRECTIVE ACTION

Update the PGM-FI software with the HDS. Replace the air/fuel sensor.

NOTE

The PGM-FI software has been changed to delay the operation of the A/F sensor heater when there is a high probability of moisture in the exhaust
system.

PARTS INFORMATION

Air/Fuel Sensor:

Base model with M/T: P/N 36531-PND-A21

Base model with A/T: P/N 36531-PNE-003

Type-S: P/N 36531-PRB-A11

SOFTWARE INFORMATION

HDS Software Version: 2.006.019 (blue) or later.

NOTE

If you use an earlier HDS software version, the HDS may incorrectly indicate that the vehicle does not need an update when it actually does.

The updated PGM-FI software program IDs and P/Ns are shown. If these, or later program IDs, are the Current Program ID displayed during the update,
the software for this service bulletin is already installed.

Computers/Controls - Updating Control Units And Modules|Page 3992 > < Computers/Controls - Updating Control Units And Modules|Page 3990