RSX L4-2.0L (2005)
5. Remove the passenger's dashboard lower cover (A).
6. Disconnect the ECM/PCM connectors (B).
7. Remove the ECM/PCM mounting bolts (C) and the ECM/PCM (D).
8. Install the ECM/PCM in the reverse order of removal.
9. Open the SCS with the HDS.
10. Turn the ignition switch ON (II).
NOTE: If DTC: P0630 "VIN Not Programmed or Mismatch" is stored at this time, ignore it and continue this procedure.
11. Input the VIN to the ECM/PCM with the HDS.
12. Rewrite the immobilizer code with the ECM/PCM replacement procedure in the HDS; it allows you to start the engine.
13. Reset the ECM/PCM with the HDS.
14. Do the ECM/PCM idle learn procedure.
15. Do the CKP pattern learn procedure.
