RSX L4-2.0L (2005)
Impact Sensor: Service and Repair
Front Impact Sensor Replacement
Front Impact Sensor Replacement
Removal
1. Disconnect the battery negative cable, and wait at least 3 minutes before beginning work.
2. Remove the front inner fender.
3. Disconnect the engine compartment wire harness 2P connector (A), and remove the two Torx bolts (B) using a Torx T30 bit, then remove the front
impact sensor (C).
Installation
1. Install the new front impact sensor with new Torx bolts (A), then connect the engine compartment wire harness 2P connector (B) to the front
impact sensor (C).
2. Reconnect the battery negative cable.
3. After installing the front impact sensor, confirm proper system operation: Turn the ignition switch ON (II); the SRS indicator should come on for
about 6 seconds and then go off.
