acura Workshop Repair Guides

Acura (Honda) Workshop Service and Repair Manuals

Refrigerant Pressure Sensor / Switch, HVAC|Locations|Page 588 > < Refrigerant Pressure Sensor / Switch, HVAC|Locations|Page 586
Page 2
background image

9. Measure the voltage between the No. 24 terminal of the climate control unit 30P connector and body ground.

Is there battery voltage? 

YES - Go to step 10.

NO - Repair open in the wire between the climate control unit and the A/C pressure switch. 

10. Turn the ignition switch OFF.

11. Measure the resistance between the No. 2 and No. 5 terminals of the climate control unit 30P connector.

Is the resistance less than 24 kOhm?

YES - Check for loose wires or poor connections at the climate control unit 30P connector and at the A/C pressure switch 2P connector. If the
connections are good, substitute a known-good climate control unit, and recheck. If the symptom/indication goes away, replace the original climate
control unit.

NO - Repair cause of high resistance in the evaporator temperature circuit. 

12. Make sure the A/C switch is OFF.

13. Measure the voltage between the No. 9 terminal of under-dash fuse/relay box connector F (12P) and body ground with the under-dash fuse/relay

box connectors connected.

Is there battery voltage?

Refrigerant Pressure Sensor / Switch, HVAC|Locations|Page 588 > < Refrigerant Pressure Sensor / Switch, HVAC|Locations|Page 586