RSX L4-2.0L (2005)
10. Install a 2 Ohm, resistor between the fuel pump 5P connector terminals No.1 and No.2, then turn the ignition switch ON (II).
11. Check that the pointer of the fuel gauge indicates "F".
-
If the pointer of the fuel gauge does not indicate "F", replace the gauge.
-
If the gauge is OK, go to step 12.
NOTE: The pointer of the fuel gauge returns to the bottom of the gauge dial when the ignition switch is OFF, regardless of the fuel level.
12. Relieve the fuel pressure.
13. Remove the fuel fill cap.
14. Disconnect the quick-connect fittings from the fuel pump.
15. Using the special tool, loosen the fuel tank unit locknut (A).
