RSX L4-2.0L (2005)
Fuel Gauge Sender: Service and Repair
Fuel Pump/Fuel Gauge Sending Unit Replacement
Special Tools Required
Fuel sender wrench 07AAA-S0XA100
1. Relieve the fuel pressure.
2. Remove the fuel fill cap.
3. Remove the rear seat cushion.
4. Remove the access panel (A) from the floor.
5. Disconnect the fuel pump 5P connector (B) and the EVAP canister vent shut valve and fuel tank pressure sensor subharness 6P connector (C).
6. Disconnect the quick-connect fitting (D) from the fuel tank unit.
7. Using the special tool, loosen the fuel tank unit locknut (A).
