RSX L4-2.0L (2005)
33. Coat the new 51 mm O-ring (D) with power steering fluid, then position it into the groove on the side plate.
34. Install the pump housing (A) over the cover assembly (B).
35. Align the bolt holes in the cover (A) with the threaded holes in the pump housing. Install the flange bolts loosely first, then torque the flange bolts
in a criss cross pattern in two or more steps.
36. Push in the cam ring (A) from the pump housing cap hole (B) with a flat bladed screwdriver, to make sure the cam ring is fully seated against the
outer case.