RSX L4-2.0L (2005)
Steering Wheel: Service and Repair
Steering Wheel Installation
Steering Wheel Installation
1. Before installing the steering wheel, make sure the front wheels are aligned straight ahead, then center the cable reel (A). Do this by first rotating
the cable reel clockwise until it stops. Then rotate it counterclockwise about two and a half turns. The arrow mark (B) on the cable reel label
should point straight up.
2. Position the two tabs (A) of the turn signal canceling sleeve (B) as shown, and install the steering wheel on to the steering column shaft, making
sure the steering wheel hub (C) engages the pins (D) of the cable reel and tabs of the canceling sleeve. Do not tap on the steering wheel or steering
column shaft when installing the steering wheel.
3. Install the steering wheel bolt (A) and tighten it.
4. Connect the cruise control set/resume switch connector.
5. Install the driver's airbag, and confirm that the system is operating properly.
6. Check the horn and turn signal canceling for proper operation.
7. Reconnect the battery and do the following:
^
Power window control unit resetting procedure.
^
ECM/PCM idle learn procedure.
^
Enter the anti-theft code for the radio, then enter the customer's radio station presets.
^
Set the clock.
