RSX L4-2.0L (2005)
Ball Joint: Service and Repair
Ball Joint Removal
Ball Joint Removal
Special Tools Required
^
Ball joint thread protector, 12 mm 07AAF-SDAA100
^
Ball joint remover, 28 mm 07MAC-SL00200
NOTICE: Always use a ball joint remover to disconnect a ball joint. Do not strike the housing or any other part of the ball joint connection to
disconnect it.
1. Install the special tool onto the threads of the ball joint (A) by hand until it stops to prevent damage to the threaded end of the ball joint pin.
2. Apply grease to the special tool on the areas shown (A). This will ease installation of the tool and prevent damage to the pressure bolt (B) threads.
3. Install the special tools as shown. Insert the jaws carefully, making sure not to damage the ball joint boot. Adjust the jaw spacing by turning the
pressure bolt (A).
4. After adjusting the adjusting bolt (B), make sure the head (C) of the adjusting bolt is in the position shown to allow the jaw to pivot.
5. With a wrench, tighten the pressure bolt until the ball joint pin pops loose from the steering arm or knuckle. If necessary, apply penetrating type
