RSX L4-2.0L (2005)
10. Install shift solenoid valve A and B. While holding the shift solenoid valve body, be sure to install the solenoid valves until their mounting bolt
brackets contact the bracket of installed, solenoid. Do not install the shift solenoid valve A and B before installing the shift solenoid valve D and
E. If solenoid valve A and B are installed, before solenoid valves D and E, it may damage the hydraulic control system.
11. Connect the shift solenoid valve D connector (G) with the ATF temperature sensor.
12. Connect the solenoid valve A connector (BLU wire), solenoid valve B connector (ORN wire), solenoid valve C connector (GRN wire), and
solenoid valve E connector (RED wire).
13. Install the shift solenoid valve cover with a new gasket and dowel pins.
14. Install the ATF cooler inlet line with the line bolt and new sealing washers. Create clearance with the transmission jack between the transmission
and the front subframe to tighten the line bolt with the torque wrench.
15. Install the bracket of the ATF cooler inlet line on the shift solenoid valve cover with the bolt.
16. Remove the transmission jack.
17. Refill the transmission with the recommended fluid.
