RSX L4-2.0L (2005)
Valve Body: Service and Repair
Valve Body
Valve Body and ATF Strainer Removal
Exploded View
NOTE: Refer to the Exploded View as needed during the following procedure.
1. Remove the ATF feed pipes from the regulator valve body, and servo body.
2. Remove the ATF strainer (two bolts).
3. Remove the servo body (13 bolts), then remove the separator plate and dowel pins (two).
4. Remove the ATF joint pipes (one bolt) from the regulator valve body.
5. Remove the regulator valve body (seven bolts).
6. Remove the stator shaft and stator shaft stop.
7. Remove the regulator separator plate and dowel pins (two).
8. Remove the cooler check valve spring:
-
2002 model (transmission number 1000001-1006166): Remove the cooler check valve spring from the main valve body, then remove the main
valve body (three bolts). Do not let the check balls and cooler check valve (ball) fall out.
-
2002 model (transmission number 1006167 or later), and 2003-2005 models: Remove the cooler check valve spring and cooler check valve