RSX L4-2.0L (2005)
6. Install the clutch master cylinder in the reverse order of removal. Install a new O-ring. Tighten the master cylinder mounting nuts to 13 Nm (1.3
kgf-m, 9.4 ft. lbs.). Make sure the tabs on the master cylinder hose clamps are pointed in the directions shown.
NOTE: When attaching the reservoir hose to the reservoir, make sure you align the yellow mark on the hose with the rib on the reservoir.
7. To prevent the retaining clip (A) from coming off, pry apart the tip of the retaining clip (B) with a screwdriver.
8. Tighten the master cylinder mounting nuts to 13 Nm (1.3 kgf-m, 9.4 ft. lbs.).
9. Bleed the clutch master hydraulic system.
NOTE: Reservoir filling is covered in the bleeding procedure.
10. Install the air cleaner housing.
