RSX L4-2.0L (2005)
9.
Reattach exhaust pipe A to the TWC with a new rear gasket and three new nuts. Torque the nuts to 33 N.m (25 lb.ft).
10.
Reconnect exhaust pipe A to its rubber hanger.
11.
Reinstall the engine under cover.
REPAIR PROCEDURE C: RL
1.
Raise the vehicle on a lift, and make sure it is securely supported.
2.
Remove exhaust pipe A:
^
Remove the three nuts that attach exhaust pipe A to each warm-up catalytic converter (six nuts total).
^
Disconnect exhaust pipe A from its rubber hanger.
^
Remove the three nuts that attach exhaust pipe A to the TWC.
3.
Make a reference mark across the propeller shaft and the transfer companion shaft, then separate the shafts (four nuts).
