RSX L4-2.0L (2005)
15. Unwind the boot band tool, and cut off the excess free end of the band to leave a 5 - 10 mm (0.2 - 0.4 inch) tail protruding from the clip.
16. Bend the band end (A) by tapping it down with a hammer.
NOTE:
-
Make sure the band and clip do not interfere with anything on the vehicle and the band does not move.
-
Remove any grease remaining on the surrounding surfaces.
17. Repeat steps 9 through 16 for the band on the other end of the boot, then go to step 18.
18. Install the new set ring.
Outboard Joint Side