RSX L4-2.0L (2005)
Power Window Switch: Testing and Inspection
Master Switch Input Test
Master Switch Input Test
NOTE: The power window control unit is built into the power window master switch, and it only controls the driver's window operations.
1. Remove the switch panel from the door panel.
2. Disconnect the 14P connector (B) from the master switch (A).
3. Inspect the connector and socket terminals to be sure they are all making good contact.
-
If the terminals are bent, loose or corroded, repair them as necessary, and recheck the system.
-
If the terminals look OK, go to step 4.
4. With the connector still disconnected, make these input tests at the connector.
-
If any test indicates a problem, find and correct the cause then recheck the system.
