RSX L4-2.0L (2005)
Front Door Window Regulator: Service and Repair
Door Glass And Regulator Replacement
NOTE: Put on gloves to protect your hands.
1. Remove these items:
-
Door panel
-
Plastic cover, as necessary
2. Carefully raise the glass (A) until you-can see the bolts, then remove them. Carefully pull the glass out through the window slot. Take care not to
drop the glass inside the door.
3. Disconnect and detach the connector (A) and harness clip (B) from the door.
4. Remove the bolts (C), and loosen the bolts (D), then remove the regulator (E) through the hole in the door.
5. Apply multipurpose grease to all the sliding surfaces of the regulator (A) where shown.
6. Install the glass and regulator in the reverse order of removal, and note these items:
-
Make sure the motor connector is plugged in properly.
